Access Control Entry/Exit Devices
- Access Control Card Readers and Keypads
- Access Control reader or keypad is not receiving power
- Alarm.com Access Control Readers - Data Sheet
- Alarm.com Smart Credentials - Data Sheet
- Can an Access Control card be configured to unlock a Z-Wave lock with a swipe?
- How do Alarm.com card and keyfob credentials work?
- Mullion Reader (ADC-AC-ET10) - Installation Guide
- Single Gang Reader (ADC-AC-ET20) - Installation Guide
- Single Gang Reader with Keypad (ADC-AC-ET25) - Installation Guide
- What is a drain wire and where does it go on the Alarm.com controller or expansion module?
- Which wire gauge should be used with Access Control Card Readers?
- Why does the LED on the reader device stay red when a door is triggered to open?
- Why does the reader or keypad continuously beep when the door is buzzed open?
- Wiegand Access Control reader or keypad is transmitting incorrect credentials or incomplete format data
- Access Control Locking Hardware
- Can Access Control be interfaced with garage door motors or gate controllers?
- Does Access Control locking hardware require a diode or MOV?
- What is the difference between fail-safe and fail-secure (normally open and normally closed) for Access Control?
- Which types of Access Control locking hardware are compatible?
- Will a door lock relock if the door's contact sensor closes?
- Access Control Request to Exit (REX) Devices
- Can Access Control be interfaced with an intercom system?
- Can voltage be applied to the input terminals on Mercury or HID controllers or expansion modules?
- Is an Access Control request to exit device necessary?
- Which REX devices are recommended for Access Control?
- Which wire gauge should be used with an Access Control Request to Exit device?
- Wire a Request to Exit (REX) device to an ADC-AC-E4MT8-PSE/ADC-AC-E8MT2-PSE
- Wire a Request to Exit (REX) device to an X100 Two Reader Expansion Module (ADC-AC-X100)
- Wire a Request to Exit (REX) device to an X1100 Door Controller (ADC-AC-X1100)
- Wire a Request to Exit (REX) motion device to an LP1501 PoE Door Controller (ADC-AC-LP1501)
- Wire a Request to Exit (REX) motion device to an LP1502 Door Controller (ADC-AC-LP1502)
- Wire a Request to Exit (REX) motion device to a Door Controller (ADC-ACC1-17)
- Wire a Request to Exit (REX) motion device to a Single Reader Expansion Module (ADC-AC-MR50)
- Wire a Request to Exit (REX) motion device to a Two Reader Expansion Module (ADC-AC-MR52)