Access Control Request to Exit (REX) Devices

Data sheets  

Installation guides

• Wire a Request to Exit (REX) device to an ADC-AC-E4MT8-PSE/ADC-AC-E8MT2-PSE

• Wire a Request to Exit (REX) device to an X100 Two Reader Expansion Module (ADC-AC-X100)

• Wire a Request to Exit (REX) device to an X1100 Door Controller (ADC-AC-X1100)

• Wire a Request to Exit (REX) motion device to a Door Controller (ADC-ACC1-17)

• Wire a Request to Exit (REX) motion device to a Single Reader Expansion Module (ADC-AC-MR50)

• Wire a Request to Exit (REX) motion device to a Two Reader Expansion Module (ADC-AC-MR52)

• Wire a Request to Exit (REX) motion device to an LP1501 PoE Door Controller (ADC-AC-LP1501)

• Wire a Request to Exit (REX) motion device to an LP1502 Door Controller (ADC-AC-LP1502)

User guides

How-to troubleshooting guides

Frequently asked questions

• Can Access Control be interfaced with an intercom system?Alarm.com Access Control doors can be unlocked using a compatible intercom system that supports a normally open or normally closed dry contact output.

• Can voltage be applied to the input terminals on Mercury or HID controllers or expansion modules?

• Is an Access Control request to exit device necessary?In most cases, yes. It is common for most doors to require allowing free egress, which may require the use of a Request to Exit device.

• Which REX devices are recommended for Access Control?

• Which wire gauge should be used with an Access Control Request to Exit device?

Videos