JascoPro Smart Water Leak Sensor (81018)

As a SmartStart device: 

For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.

As an S2 device: 

For information about this process, see Add an S2-encrypted Z-Wave device.

As an S0 device: 

1. Place the Z-Wave controller into Add Mode.
2. Press and release the programming button. This starts the manual add process. The blue LED flashes quickly as it searches for a network.
3. When the sensor is joined to the network, the green LED lights for 2 seconds. After 25 seconds, the blue LED will stop flashing if the sensor is not added to the network.
4. If prompted by the controller to enter the S2 security code, refer to the QR code/security number on the back of the box or the QR code label on the product. Enter the 5-digit code.
5. The green LED will activate for two seconds to confirm the sensor has been added in the network.