Enroll, delete, or reset a JascoPro Smart Water Leak Sensor (81018)

As a SmartStart device:

It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).

For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.

As an S2 device:

If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.

For information about this process, see Add an S2-encrypted Z-Wave device.

As an S0 device:

If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.

1. Place the Z-Wave controller into Add Mode.
2. Press and release the programming button. The blue LED flashes quickly as it searches for a network.
3. When the sensor is joined to the network, the green LED lights for 2 seconds.
   • After 25 seconds, the blue LED will stop flashing if the sensor is not added to the network.
4. If prompted by the controller to enter the S2 security code, refer to the QR code/security number on the back of the box or the QR code label on the product. Enter the 5-digit code.
5. The green LED will activate for two seconds to confirm the sensor has been added in the network.