Factory reset an ADC-V722W to its default settings

Last updated
Save as PDF

Resetting a video device to its factory defaults removes all programming and memory from the device.

Important: Wait at least two minutes for the video device to power on fully before performing the following procedure. The factory reset might fail if the device is still powering on.

Reset procedure	Reset button location	Reset button image
Press and hold the [WPS] button for 10-15 seconds until the LED alternates red and green. Wait for the device to reboot and revert to Access Point (AP) mode (blinking white).	The [WPS] button can be found on the back of the camera.