What do the LEDs on the ADC-V520IR mean?
| LED pattern | Status | Description |
|---|---|---|
|
Solid green
|
Connected to the internet | Local network and internet connection with Alarm.com IP. |
|
Blinking green
|
Local network connection |
Local network connection with the local IP address, no internet. Note: If the LED does not go to solid green after a few minutes, see Camera LED is blinking green. |
|
Solid red
|
Power on, or no network connection |
Power on, system booting up typically 60-90 seconds. If solid red for longer than 60-90 seconds, then there is no local or Internet connection. |
|
Blinking red
|
Camera powering on, or firmware update (for version 101d + only) |
On camera firmware version 101d +, this indicates the camera is powering on or a firmware update is in progress. Note: If the camera below version 101d, blinking red is not an expected LED behavior. |
|
Blinking blue
|
WPS mode |
WPS mode is active. To enter WPS mode, press and hold the WPS button for 3 seconds. |
|
Solid blue
|
Privacy mode |
Privacy mode is active. To toggle privacy mode on/off, press and release the WPS button. |
|
Blinking red and green
|
Factory reset |
The camera is restoring to factory default settings. Caution: If the camera is already installed, it may need to be removed from the Alarm.com account and re-added after a factory reset. To perform a factory reset, use a thin tool (e.g. paperclip) to hold the reset button for about 10–15 seconds. |
