Factory reset an ADC-V522IR to its default settings

Last updated
Save as PDF

Resetting a video device to its factory defaults removes all programming and memory from the device.

Important: Wait at least two minutes for the video device to power on fully before performing the following procedure. The factory reset might fail if the device is still powering on.

Reset procedure	Reset button location	Reset button image
Press and hold the [WPS/Reset] button for 10-15 seconds until the LED alternates flashing red and green. Wait for the device to reboot. After being factory reset, the Indoor Fixed w/IR (ADC-V522IR) reverts to Access Point mode (blinking white LED).	The [WPS/Reset] button is on the back of the camera.

Reset procedure

Reset button location

Reset button image

Press and hold the [WPS/Reset] button for 10-15 seconds until the LED alternates flashing red and green.
Wait for the device to reboot.

After being factory reset, the Indoor Fixed w/IR (ADC-V522IR) reverts to Access Point mode (blinking white LED).

The [WPS/Reset] button is on the back of the camera.