2GIG Z-Wave Plus Battery Powered Thermostat (2GIG-STZ-1)
- Last updated
-
-
Save as PDF
Notice: The 2GIG-STZ-1 is not compatible with the SEM-Honeywell/ADEMCO or SEM-DSC PowerSeries.
Quick Facts
| Device Image |
.jpg?revision=1&size=bestfit&width=247&height=250) |
| Manufacturer |
Nice North America, LLC |
| Power |
Battery or AC |
| Z-Wave Security 2 (S2) |
Yes
Note: The S2 DSK string, PIN code, and QR code are printed on a label above the LCD screen under the faceplate.
|
| Local Thermostat Schedules |
No |
| Alarm.com Auto Mode |
Yes
Note: The thermostat requires at least one heating stage and one cooling stage to support Auto Mode.
|
| Enrollment Button Location |
- Set your primary controller to Include, add or Install mode, to add the thermostat as a node on your network (see your controller’s user manual for detailed instructions).
- Touch any button to take the thermostat out of sleep mode.
- Touch and hold MODE button for 5 seconds. SETUP will be displayed in the status display line.
- Scroll to Z-Wave using up/down arrow buttons. Touch FAN (Select).
- When prompted by your Z-Wave controller, select YES in the Z-Wave Install screen.
- Touch FAN (Select) to add thermostat to the network.
- The display line should flash WAIT and then DONE if Z-Wave connection is made.
- If Z-Wave does not connect to controller, WAIT, then FAIL will flash in status display line.
- If thermostat fails to connect, repeat steps three (3) through (7) to re-try connecting.
|
| Reset Option |
- Touch and hold MODE button to go to Setup menu.
- Touch and hold MODE and the down arrow key to enter Advanced Menu.
- Scroll up to Restore Defaults.
- Touch FAN (Select). Select will flash while the thermostat resets.
- Touch MODE (Done) when reset completes.
|
How-to troubleshooting guides
Frequently asked questions
