Westinghouse RTS-PZA Commercial Lever Lock
Quick facts
| Device Image | .png?revision=1&size=bestfit&width=250&height=250) |
|---|---|
| Manufacturer | Westinghouse |
| User Code Limit | 255 |
| Digits in User Code | 4 to 8 |
| S2 | No. |
| Keypad Layout | 1 digit per button on the front. Menu, up/down arrows, and Exit button on the back. |
| Auto Re-lock Option | No, but other programming is available. For more information, see the Installation Guide. |
| Mate Button Location |
This lock is put into enroll mode by pressing M on the back of the lock, then scrolling down to “7. Zwave”. Press M to select. Scroll to “1. Zwave Inclusion”. Press M to select. Wait until the lock displays “Success!”. The RTS-PZA has now been included in the network and can be managed by the Alarm.com controller. The lock is put into delete mode by pressing M then scrolling down to “7. Zwave”. Press M to select. Scroll to “2. Zwave Exclusion”. Press M to select. Wait until the lock displays “Success!”. The RTS-PZA has now been excluded from the network. |
| Removable Z-Wave Card | No. |
| Factory Reset Method |
Note: This will reset the lock's Master Code, and a new Master Code will need to be programmed following the reset process. Steps: The reset button is located above the battery carriage on the top left side. A paperclip or pin will be needed to depress the button inside of the pinhole. Pressing the reset button and holding it for about five seconds will erase all existing codes and restore the lock’s settings to factory default except for Z-Wave connection. |
Compatibility Alert
Alarm.com no longer supports new installations of the Westinghouse RTS-PZA Commercial Lever Lock. We continue to support previously installed devices. If the device is deleted and then re-added to the network, there is no guarantee it will function properly.
Please visit the Ecosystem page to view supported devices currently available for purchase.