Schlage Z-Wave Touchscreen Deadbolt (BE468)

Device Image
Manufacturer	Schlage
User Code Limit	30
Digits in User Code	4
S2	No
Keypad Layout	1 digit per button
Auto Re-lock Option	Yes
Mate Button Location	This lock can be put into add or delete mode by pressing the Schlage button, entering the Programming Code found on the inside label of the lock, and finally the 0 button.
Removable Z-Wave Card	No
Factory Reset Method	Disconnect the batteries. Press and hold the outside Schlage Button. While holding the outside Schlage Button, reconnect the batteries. Release the outside Schlage Button. To check that the lock was reset, press the Outside Schlage Button and enter one of the Default User Codes. If the reset was successful, the Default User Codes will unlock the deadbolt.
Handing Process	For a new lock (or after a factory reset), press the Schlage button first to enable the backlight. Enter one of the Default User Codes into the lock Note: Default User Codes are on a label at the top of the printed instructions that come with the lock. They cannot be retrieved by Alarm.com or by Schlage. Factory resets should not be attempted if the default codes are lost.

Schlage Z-Wave Touchscreen Deadbolt (BE468) - Installation GuideThis is an install guide for the Schlage Z-Wave Touchscreen Deadbolt (BE468).

Schlage Z-Wave Touchscreen Deadbolt (BE468) - Thick Door Installation GuideThis is an install guide for the Schlage Z-Wave Touchscreen Deadbolt (BE468) Thick Door Kit.

Schlage Z-Wave Touchscreen Deadbolt (BE468) - User GuideThis is a user guide for the Schlage Z-Wave Touchscreen Deadbolt (BE468).