Schlage J Series Locks (JBE109 & JFE109)

If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.

1. Place the Z-Wave Controller into the Add Mode. Refer to the respective documentation for your home automation system for details.
2. Remove the battery cover.
3. Press and hold the enrollment button under the battery cover for 0.5 to 3 seconds. Solid amber LED will be ON.
    
4. Release the enrollment button. An LED will flash amber indicating the enrollment process is in progress.
   
   Note: For enrollment in some Z-Wave Plus networks, an additional 5 digit code may be required to be entered into the home automation system or panel during Step 4. Enter the 5 digit code shown on the label located on the lock or on the cover of the included installation instructions. Refer to your home automation system’s documentation or app for more information.
    
5. Success is indicated by a green LED blink and a beep. If a red LED turns on, try repeating steps 1-3.

1. Remove one battery.
2. Press .
3. Replace the battery then wait until power up is complete, indicated by 1 long green blink and 1 long beep. You must complete the next step within 10 seconds.
4. Press and hold  for 3 seconds. Successful FDR is indicated by 3 long green blinks and 3 long beeps.