Enroll, delete, or reset an Eaton Z-Wave In-Wall On/Off Switch (RF9601)
The Eaton Z-Wave In-Wall On/Off Switch (RF9601) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing an Eaton Z-Wave In-Wall On/Off Switch (RF9601), see Eaton Z-Wave In-Wall On/Off Switch (RF9601) - Installation Guide.
To enroll an Eaton Z-Wave In-Wall On/Off Switch into a Z-Wave network:
This device is only compatible with Z-Wave controllers that support Z-Wave Security 2 (S2), so it must be enrolled as an S2 device for enhanced security and encryption features. For information about this process, see Add an S2-encrypted Z-Wave Device.
To delete an Eaton Z-Wave In-Wall On/Off Switch from a Z-Wave network:
- Place the Z-Wave controller into Delete Mode.
- Press the On/Off switch one time.
- The blue indicator LED on the device will start blinking when the device has been successfully deleted.
To reset an Eaton Z-Wave In-Wall On/Off Switch:
- Apply power to the device.
- Press and hold the On/Off button for 20 seconds. The indicator LED will flash three times.
- Release the On/Off button.
- The indicator LED will flash rapidly. When it slows to a steady blink, the device has been successfully reset.