Eaton Z-Wave In-Wall On/Off Switch (RF9601)
Quick facts
| Device Image | .png?revision=1&size=bestfit&width=250&height=250) |
|---|---|
| Manufacturer | Eaton |
| Power Requirements | 120 VAC, 60 Hz |
| Maximum Load | 15 Amps |
| Dimming | No |
| Z-Wave Security 2 (S2) | Yes |
| Z-Wave SmartStart | No |
| Z-Wave Enrollment |
This device is only compatible with Z-Wave controllers that support Z-Wave Security 2 (S2), so it must be enrolled as an S2 device for enhanced security and encryption features. For information about this process, see Add an S2-encrypted Z-Wave Device. |
Data sheets
Installation guides
- Enroll, delete, or reset an Eaton Z-Wave In-Wall On/Off Switch (RF9601)The Eaton Z-Wave In-Wall On/Off Switch (RF9601) can be enrolled into or deleted from a Z-Wave network following the instructions below.