Factory reset an ADC-VC726 to its default settings

Last updated
Save as PDF

Resetting a device to its factory default settings removes all of its existing programming and memory. Most devices must be removed from the account and re-enrolled after a factory reset.

Reset procedure	Reset button location	Reset button image
Remove power from the device. Use the hex key that comes with the ADC-VC726 to remove the water-tight door on the bottom of the camera to reveal the reset button. Press and hold the [Reset] button while reconnecting power. After reconnecting power, continue to hold the [Reset] button for 10 seconds. Important: After performing a factory reset, it is strongly recommended to leave the device alone and plugged into power for two minutes.	The Reset button can be found on the back of the camera.

Reset procedure

Reset button location

Reset button image

Remove power from the device.
Use the hex key that comes with the ADC-VC726 to remove the water-tight door on the bottom of the camera to reveal the reset button.
Press and hold the [Reset] button while reconnecting power.
After reconnecting power, continue to hold the [Reset] button for 10 seconds.

Important: After performing a factory reset, it is strongly recommended to leave the device alone and plugged into power for two minutes.

The Reset button can be found on the back of the camera.