Versa LAMP-ZW2 Plug-in Dimmer
Quick Facts
| Manufacturer | Versa |
|---|---|
| Power Requirements | 125VAC 60Hz |
| Maximum Load |
|
| Dimming | Compatible |
| Z-Wave Security 2 (S2) | Compatible |
| Z-Wave SmartStart | Compatible |
| Z-Wave Long Range | Compatible |
| Z-Wave Frequency | 908.42 MHz |
The Versa LAMP-ZW2 Plug-in Dimmer can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installation, see the manufacturer's Versa LAMP-ZW2 Plug-in Dimmer - Installation Guide.
To enroll a Versa LAMP-ZW2 Plug-in Dimmer:
This device can be enrolled using the method as a SmartStart, S2, or S0 device.
To enroll as a SmartStart device:
It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).
For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.
To enroll as an S2 device:
If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.
For information about this process, see Add an S2-encrypted Z-Wave device.
To enroll as an S0 device:
If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.
- Place the Z-Wave controller into Add Mode.
- Press the Manual/Program button on the smart plug 3 times quickly. The blue LED will flash quickly.
- The LED will light solid blue when the device is successfully added to the Z-Wave® network.
To delete a Shelly Wave Pro Dimmer 2PM:
- Place the Z-Wave controller into Delete Mode.
- Press the Manual/Program button on the smart plug 3 times quickly. The purple LED will flash to indicate it is in exclusion mode.
To reset a Shelly Wave Pro Dimmer 2PM:
- Press the Manual/Program button twice quickly, then hold the third press for 10 seconds.
Troubleshooting