Enroll, delete, or reset a Sengled LED Bulb
The Sengled LED Bulb (V11-N13-US) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a Sengled LED Bulb (V11-N13-US), see Sengled LED Bulb (V11-N13-US) - Installation Guide.
To enroll a Sengled LED Bulb (V11-N13-US)
As a SmartStart device:
It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).
For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.
As an S2 device:
If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.
For information about this process, see Add an S2-encrypted Z-Wave device.
As an S0 device:
If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.
- Place the Z-Wave controller into Add Mode.
- Perform a 2-second power cycle to the bulb.
- The bulb will flash twice to indicate a successful pairing.
To delete a Sengled LED Bulb (V11-N13-US)
- Place the Z-Wave controller into Delete Mode.
- Perform a 2-second power cycle to the bulb.
To reset a Sengled LED Bulb (V11-N13-US)
- Power cycle the bulb at least five times.
- The bulb will flash three times to indicate a successful reset.
Troubleshooting