Nice Roll-Control2
Quick facts
| Device Image |  |
|---|---|
| Manufacturer | Nice |
| Power Requirements | 100-240 V~ 50/60 Hz |
| Maximum Load | 2 A for motors with compensated power factor (inductive loads) |
| Z-Wave Security 2 (S2) | Compatible |
| Z-Wave SmartStart | Compatible |
| Z-Wave Frequency |
These Nice Multi-Channel devices are supported anywhere the following frequencies are supported:
|
The Nice Roll-Control2 can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a Nice Roll-Control2, see Nice Roll-Control2 - Installation Manual.
To enroll a Nice Roll-Control2:
For more information about adding Z-Wave devices, see Add Z-Wave devices.
To trigger the device for local enrollment using Add Mode:
If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.
- Verify the device is connected to power. Verify the red LED glows (not yet added).
- Place the Z-Wave controller into Add Mode.
- Quickly, click the PROG button on the device three times. Alternatively, click S1 or S2 three times quickly.
- Wait for the LED indicator to blink yellow.
- Successful addition is confirmed by the Z-Wave controller message and the device LED indicator:
- Green – successful (non-secure, S0, S2 non-authenticated)
- Magenta – successful (Security S2 Authenticated)
- Red – not successful
Note: If you're adding the device in the Security S2 Authenticated mode manually, input the PIN Code, which is labeled on the device. The PIN Code is also an underlined part of the device-specific key (DSK) labeled at the bottom of the box.
To delete a Nice Roll-Control2:
- Place the Z-Wave controller into Delete Mode.
- Quickly, click the PROG button three times. Alternatively, click quickly S1 or S2 three times within 10 minutes of powering up the device.
- Wait for the removal process to end.
- Successful removal is confirmed by the Z-Wave controller message.
- The device LED indicator glows red.
To reset a Nice Roll-Control2:
- Switch off the mains voltage (disable the fuse).
- Remove the device from the wall switch box.
- Switch on the mains voltage.
- Press and hold the PROG button to enter the menu.
- Wait for the LED indicator to glow yellow.
- Quickly release and click the PROG button again.
- During the factory reset, the LED indicator blinks yellow.
- After a few seconds, the device is restarted, which is signaled with the red color of the LED indicator.