Nice DoubleDimmer-Control
Quick facts
| Device Image |  |
|---|---|
| Manufacturer | Nice |
| Power Requirements | 220–240 VAC 50/60 Hz |
| Maximum Load | 0.3 A per channel, which means a maximum of 70 W for a load with Power Factor = 1 at 230 VAC |
| Z-Wave Security 2 (S2) | Compatible |
| Z-Wave SmartStart | Compatible |
The Nice DoubleDimmer-Control can be enrolled in or removed from a Z-Wave network by using the following instructions.
For more information about installing the device, refer to the manufacturer's Nice DoubleDimmer-Control - Installation Manual.
For an overview of the device, refer to the manufacturer's Nice DoubleDimmer-Control Overview.
To enroll a Nice DoubleDimmer-Control:
For more information about adding Z-Wave devices, see Add Z-Wave devices.
To trigger the device for local enrollment using Add Mode:
- Place the DoubleDimmer-Control within the direct range of your Z-Wave controller.
- Place the Z-Wave controller into Add Mode.
- Quickly press the S1 or S2 switch, or the PROG button on the device, three times.
- If you are adding the device in S2 Authenticated mode, enter the PIN Code labeled on the device. The PIN Code is also an underlined part of the device specific key (DSK) labeled at the bottom of the box.
- Wait for the adding process to complete.
- Successful addition is confirmed by the Z-Wave controller message and the device LED indicator:
- Green – successful (non-secure, S0, S2 non-authenticated)
- Magenta – successful (Security S2 Authenticated)
- Red – not successful
To delete a Nice DoubleDimmer-Control:
- Place the Z-Wave controller into Delete Mode.
- Quickly, click the PROG button three times. Alternatively, click quickly S1 or S2 three times within 10 minutes of powering up the device.
- Wait for the removal process to end.
- Successful removal is confirmed by the Z-Wave controller message.
- The device LED indicator glows red.
To reset a Nice DoubleDimmer-Control:
- Switch off the mains voltage (disable the fuse).
- Remove the device from the wall switch box.
- Switch on the mains voltage.
- Press and hold the PROG button to enter the menu.
- Wait for the LED indicator to glow yellow.
- Quickly release and click the PROG button again.
- During the factory reset, the LED indicator blinks yellow.
- After a few seconds, the device is restarted, which is signaled with the red color of the LED indicator.