Enroll, delete, or reset a Jasco Z-Wave In-Wall Wireless Smart Switch (14318)
The Jasco Z-Wave In-Wall Wireless Smart Switch (14318) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a Jasco Z-Wave In-Wall Wireless Smart Switch, see Jasco Z-Wave In-Wall Wireless Smart Switch (14318) - Installation Guide.
To enroll a Jasco Z-Wave In-Wall Wireless Smart Switch into a Z-Wave network:
- Place the Z-Wave controller into Add Mode.
- Press and release either the top or bottom of the switch rocker.
- Verify that the device shows up on the Alarm.com customer website or Alarm.com app and responds to commands to turn the device on/off.
To delete a Jasco Z-Wave In-Wall Wireless Smart Switch from a Z-Wave network:
- Place the Z-Wave controller into Delete Mode.
- Press and release either the top or bottom of the switch rocker.
To reset a Jasco Z-Wave In-Wall Wireless Smart Switch:
- Quickly press the top of the switch rocker three times, then immediately press the bottom of the switch paddle three times.
- The LED will flash five times to indicate a successful reset.