Enroll, delete, or reset an Eaton Z-Wave Outlet (RFTR9605-T)
The Eaton Z-Wave Outlet (RFTR9605-T) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a Eaton Z-Wave Outlet (RFTR9605-T), see Eaton Z-Wave Outlet (RFTR9605-T) - Installation Guide.
To enroll an Eaton Z-Wave Outlet (RFTR9605-T) into a Z-Wave network:
This device is only compatible with Z-Wave controllers that support Z-Wave Security 2 (S2), so it must be enrolled as an S2 device for enhanced security and encryption features. For information about this process, see Add an S2-encrypted Z-Wave Device.
To delete an Eaton Z-Wave Outlet (RFTR9605-T) from a Z-Wave network:
- Place the Z-Wave controller into Delete Mode.
- Press the On/Off switch one time.
- The LED will blink when the device is successfully deleted.
To reset an Eaton Z-Wave Outlet (RFTR9605-T):
- Apply power to the device.
- Press and hold the ON/OFF button for 20 seconds. The indicator LED will flash three times.
- Release the ON/OFF button.
- The indicator LED will flash rapidly. When it slows to a steady blink, the device has been successfully reset.