Skip to main content
Knowledge Base

Factory reset a LiftMaster MyQ Smart Garage Hub

  1. Last updated
  2. Save as PDF

Performing a factory reset on a Liftmaster MyQ Smart Garage Hub will restore the Wi-Fi hub to its factory default settings. 

Note: Factory resetting the Wi-Fi hub does not remote controls or keyless entry codes. This differs from Wi-Fi Garage Door Opener motors, which would remove remote controls and keyless entry codes. 

To factory reset an 821LM, 821LMB, MyQ-G0301, or MyQ-G0401-ES:

  1. Press and hold 821LM gear button.png on the Wi-Fi Hub until the blue LED blinks, then release.
  2. While the blue LED is blinking, hold 821LM gear button.png on the Wi-Fi Hub again until the blue LED pauses, then blinks again. You will also hear a beep and see the yellow LED briefly blink.
  3. The Wi-Fi Hub is now restored to its' factory default settings.

To factory reset an 821LMC-S:

  1. Press and hold 821LM gear button.png on the Wi-Fi Hub until the blue LED blinks, then release. If the LED is already blinking blue, skip to step 2.
  2. While the blue LED is blinking, hold 821LM gear button.png on the Wi-Fi Hub again until the blue LED pauses, then blinks again. You may also hear a beep and see all of the LEDs briefly blink.
  3. The Wi-Fi Hub is now restored to its factory default settings.