Jasco Smart Flood/Freeze Sensor

Device Image
Manufacturer	Jasco
Power Requirements	1 CR123A battery
Environment	Indoor
Operating Temperature	32–104° F (0–40° C)
Z-Wave Security 2 (S2)	Yes
Z-Wave SmartStart	Yes
Z-Wave Enrollment	As a SmartStart device: For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device. As an S2 device: For information about this process, see Add an S2-encrypted Z-Wave device. As an S0 device: Place the Z-Wave controller into Add Mode. Remove the top cover of the sensor. Verify the battery is installed with the correct polarity and the battery tab has been removed, or verify the micro USB is plugged into USB port. Press and release the programming button. The red LED will flash quickly as it searches for a network. After 25 seconds, the LED will stop flashing if the sensor is not added to the network. Press the programming button to manually start the add process. If it times out, the LED will stop flashing. Press and release the programming button again. The red LED will turn on for 3 seconds to confirm the sensor has been added in the network. Note: Your controller may need to be within 10 feet of the sensor to be added.

Enroll, delete, or reset a Jasco Smart Flood/Freeze SensorEnroll a Jasco Smart Flood/Freeze Sensor into a Z-Wave network using SmartStart, S2, or S0, depending on controller compatibility.