Factory reset an ADC-VC836 to its default settings

Reset Procedure	Reset button location	ADC-VC836 image
Disconnect the camera from the power supply. Use a Phillips-head screwdriver to remove the water-tight door. Press and hold the Reset button while reconnecting power. Continue to hold the Reset button for 10 seconds. Important: After performing a factory reset, it is strongly recommended to leave the device alone and plugged into power for two minutes.	Under the water-tight door on the bottom of the turret.

Reset Procedure

Reset button location

ADC-VC836 image

Disconnect the camera from the power supply.
Use a Phillips-head screwdriver to remove the water-tight door.
Press and hold the Reset button while reconnecting power. Continue to hold the Reset button for 10 seconds.

Important: After performing a factory reset, it is strongly recommended to leave the device alone and plugged into power for two minutes.

Under the water-tight door on the bottom of the turret.

Important: If the camera was previously installed on an Alarm.com account, it will need to be deleted before it can be installed again.