What do the LEDs on the ADC-VDB750 mean?
Note: The ADC-VDB750 does not give an indication when it detects motion or a button press.
If the indoor chime is enabled for the device, holding down the button will trigger a single indoor chime immediately after being pressed. If desired, the indoor chime can be disabled through the Customer Website before pressing the button to initiate one of the modes below.
Status light guide
| LED pattern | Description |
|---|---|
|
Off
|
Power off |
|
Blinking yellow
|
Camera power cycling (press and hold button for 40-45 seconds) |
|
Solid red
|
No local or Internet connection |
|
Blinking red
|
Power on, camera booting |
|
Alternating red and green
|
Camera resetting to factory default (press and hold button for 45-50 seconds) |
|
Solid green
|
Connected to Alarm.com |
|
Blinking green
|
Local network connection |
|
Blinking blue
|
WPS mode (press and hold button for 30-35 seconds) |
|
Double-blinking blue
|
Unable to ring indoor chime On firmware version 02093+, this will occur when the button has been pressed more than 3 times within 60 seconds and the doorbell is not receiving sufficient power from the circuit to ring the indoor chime. |
|
Blinking white
|
Wi-Fi Access Point mode (press and hold button for 35-40 seconds) |
|
Alternating blue and green
|
Firmware update |
