Factory reset an ADC-V730/VC730P to its default settings

Last updated
Save as PDF

Resetting a video device to its factory defaults removes all programming and memory from the device.

Important: Wait at least 2 minutes for the video device to power on fully before performing the following procedure. The factory reset might fail if the device is still powering on.

Reset procedure	Reset button location	Reset button image
Press and hold the WPS/Reset button until the LED is flashing green and red (about 12 seconds), then release the button. The camera will reboot to factory default.	In front of the SD card door on the bottom of the device.	Ambient Light Sensor Microphone Spotlight Status LED WPS/Reset Button SD Card Slot SD Card Door Speaker

Reset procedure

Reset button location

Reset button image

Press and hold the WPS/Reset button until the LED is flashing green and red (about 12 seconds), then release the button.
The camera will reboot to factory default.

In front of the SD card door on the bottom of the device.

V730rev_overview v2_numbered.png

Ambient Light Sensor
Microphone
Spotlight
Status LED
WPS/Reset Button
SD Card Slot
SD Card Door
Speaker

Important: Once a video device has been reset, it is normal for the LED to turn off momentarily. It is best to leave the video device plugged into power and undisturbed for 2 minutes after performing the factory reset.