Honeywell T6 Pro Z-Wave Programmable Thermostat
The Honeywell T6 Pro Z-Wave Programmable Thermostat can be enrolled in or removed from a Z-Wave network by following the instructions below.
For more information about installation, see the manufacturer's Honeywell T6 Pro Z-Wave Programmable Thermostat - Installation Guide.
To enroll a Honeywell T6 Pro:
To locally add the thermostat to the controller:
During the initial setup:
- After you finish the installer setup and set the date and time, you will be asked to add the thermostat to the Z-Wave network. Tap Yes to include the thermostat in a Z-Wave network.
- Place the Z-Wave controller into Add Mode.
- Tap Select on the thermostat.
- If the inclusion procedure is successful, INCLUDED, the node ID, and the Z-Wave connected status icon appear on the screen. Your controller will also indicate whether the thermostat was successfully added to its network. Refer to the user manual of your Z-Wave controller.
- If the procedure fails, FAILED TO INCLUDE appears on the screen. If this happens, position the thermostat closer to the Z-Wave controller and repeat the inclusion procedure.
After the initial setup:
- Place the Z-Wave controller into Add Mode.
- Put the thermostat into inclusion mode:
- Tap Menu.
- Tap Z-Wave Setup.
- Tap Start Including.
Note: If the device is already included on a network, it offers an option to remove.
- If the inclusion procedure is successful, INCLUDED, the node ID, and the Z-Wave connected status icon appear on the screen. Your controller will also indicate whether the thermostat was successfully added to its network. Refer to the user manual of your Z-Wave controller.
- If the procedure fails, FAILED TO INCLUDE appears on the screen. If this happens, position the thermostat closer to the Z-Wave controller and repeat the inclusion procedure.
To delete a Honeywell T6 Pro:
- Place the Z-Wave controller into Delete Mode.
- Put the thermostat into delete mode:
- Tap Menu.
- Tap Z-Wave Setup.
- Tap Start Excluding.
Note: If the device is not already included on a network, it offers an option to include.
- The device and Z-Wave controller should indicate when it is successfully deleted. An excluded thermostat will also show zero for the Node ID (000) in the thermostat's device info (Menu > Device Info).
To reset a Honeywell T6 Pro:
Caution: Performing a factory reset will change all thermostat and system type settings back to factory defaults.
- Tap and hold Menu for 5 seconds to access the advanced menu.
- Tap
until you see the Reset option. - Tap to select to factory reset the thermostat.
Additional considerations
T6 Pro model TH6320ZW2007
The TH6320ZW2007 has the same limitations as the TH6320ZW2003, except as noted below:
- The TH6320ZW2007 is not compatible with GC3 or GC3e panels.
T6 Pro model TH6320ZW2003
- Alarm.com does not support humidity display or control for this thermostat.
- Auto mode is not enabled by default on the thermostat.
- Alarm.com does not receive proactive fan mode change reports from the thermostat.
- This thermostat is not eligible for Heating and Cooling Health reports.
- Battery life estimates in battery mode may not be fully accurate.
- In older versions of the thermostat, operating states do not report to Alarm.com without AC power connected.
- This thermostat does not support remote configuration.