Enroll, delete, or reset an inovelli Z-Wave® Long Range Smart Dimmer (VZW31-SN)
The inovelli Z-Wave® Long Range Smart Dimmer (VZW31-SN) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing an inovelli Z-Wave® Long Range Smart Dimmer (VZW31-SN), see inovelli Z-Wave® Long Range Smart Dimmer (VZW31-SN) - Installation Guide.
To enroll an inovelli Z-Wave® Long Range Smart Dimmer (VZW31-SN) into a Z-Wave network:
As a SmartStart device:
It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).
For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.
As an S2 device:
If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.
For information about this process, see Add an S2-encrypted Z-Wave Device.
As an S0 device:
- Put the Z-Wave controller into Add Mode.
- Quickly press the configuration button three times.
- The LED bar will blink green to indicate a successful pairing.
To delete an inovelli Z-Wave® Long Range Smart Dimmer (VZW31-SN) from a Z-Wave network:
- Place the Z-Wave controller into Delete Mode.
- Quickly press the configuration button three times.
- The LED bar will blink green to indicate a successful deletion.
To reset an inovelli Z-Wave® Long Range Smart Dimmer (VZW31-SN):
Caution: Only use this procedure in the event that the network primary controller is missing or otherwise inoperable.
- Hold the configuration button, then the top paddle for 20 seconds until the LED bar turns red.
- The LED bar will blink red to indicate it was factory reset.