Enroll, delete, or reset an inovelli RGBW Multi-Color Bulb (LZW42)
The inovelli RGBW Multi-Color Bulb (LZW42) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing an inovelli RGBW Multi-Color Bulb (LZW42), see inovelli RGBW Multi-Color Bulb (LZW42) - Installation Guide.
To enroll an inovelli RGBW Multi-Color Bulb (LZW42) into a Z-Wave network:
- With the bulb powered off, place the Z-Wave controller into Add Mode.
- Apply power to the bulb.
- The bulb will blink twice to indicate it is in Add Mode.
- The bulb will blink once more to indicate it has successfully enrolled.
To delete an inovelli RGBW Multi-Color Bulb (LZW42) from a Z-Wave network:
- Place the Z-Wave controller into Delete Mode.
- Apply power to the bulb.
- The bulb will blink twice, indicating it is in Delete Mode.
- The bulb will blink once more when it is successfully deleted.
To reset an inovelli RGBW Multi-Color Bulb (LZW42:
Caution: Only use this procedure in the event that the Z-Wave controller is missing or otherwise inoperable.
- Power the bulb on and off six times (between 0.5-2 seconds each time).
- The bulb will flash twice when it has been reset to factory settings.