Shelly Wave 1PM

If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled as an S0 device.

Using the S button:  

1. Plug in the device and verify the blue LED is flashing.
2. Place the Z-Wave controller into Add Mode.
3. Press and hold the S button until the LED turns solid blue. 
4. Quickly release and then press and hold the S button on the device until the blue LED starts blinking in mode 3. Then release the S button to initiate learn mode. 
5. The blue LED will begin flashing. 
6. The green LED will flash when the device is successfully enrolled.

Using a switch/push button:  

1. Plug in the device and verify the blue LED is flashing.
2. Place the Z-Wave controller into Add Mode.
3. Toggle the switch/push button three times within 3 seconds. The blue LED will flash during this process.
4. The green LED will flash green when the device is successfully enrolled.