Enroll, delete, or reset a Jasco Enbrighten No-Neutral Smart Dimmer (52252/52253/ZW3012)
The Jasco Enbrighten No-Neutral Smart Dimmer (52252/52253/ZW3012) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a Jasco Enbrighten No-Neutral Smart Dimmer (52252/52253/ZW3012), see Jasco Enbrighten No-Neutral Smart Dimmer (52252/52253/ZW3012) - Installation Guide.
To enroll a Jasco Enbrighten No-Neutral Smart Dimmer (52252/52253/ZW3012) into a Z-Wave network:
As a SmartStart device:
It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).
For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.
As an S2 device:
If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.
For information about this process, see Add an S2-encrypted Z-Wave device.
As an S0 device:
If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.
- Place the Z-Wave controller into Add Mode.
- Press and release the top or bottom rocker.
To delete a Jasco Enbrighten No-Neutral Smart Dimmer (52252/52253/ZW3012) from a Z-Wave network:
- Place the Z-Wave controller into Delete Mode.
- Press and release the top or bottom rocker.
To reset a Jasco Enbrighten No-Neutral Smart Dimmer (52252/52253/ZW3012):
Note: This action should only be completed if the Z-Wave controller is missing or inoperable.
- Quickly press the top rocker on the dimmer three times, then immediately press the bottom rocker three times.
- The LED will flash on and off five times to indicate a successful reset.