Enroll, delete, or reset an Evolve In-Wall Dimmer (LRM-AS or LRM-15)
The Evolve In-Wall Dimmer (LRM-AS or LRM-15) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing an Evolve In-Wall Dimmer (LRM-AS or LRM-15), see Evolve In-Wall Dimmer (LRM-AS or LRM-15) - Installation Guide.
To enroll an Evolve In-Wall Dimmer into a Z-Wave network:
- Install the device in its permanent location.
- Place the Z-Wave controller into Add Mode.
- Tap the dimmer paddle once.
- Verify that the device shows up on the Alarm.com customer website or Alarm.com app and responds to commands to turn the device on/off.
To delete and reset an Evolve In-Wall Dimmer from a Z-Wave network:
- Place the Z-Wave controller into Delete Mode.
- Tap the dimmer switch three times, then press and hold the dimmer switch.