Enroll, delete, or reset a JascoPro Smart Indoor Door/Window Sensor (84142)

As a SmartStart device:

It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).

For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.

As an S2 device:

If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.

For information about this process, see Add an S2-encrypted Z-Wave device.

As an S0 device:

If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.

1. Place the Z-Wave controller into Add Mode.
2. Press and release the programming button. This starts the manual add process. The LED flashes blue quickly as the add process begins.  
3. The LED illuminates green for 2 seconds to confirm the sensor has been added to the network.