Enroll or delete an Alarm.com Dry Contact Sensor (ADC-S40-DC)

As a SmartStart device:

It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).

For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.

As an S2 device:

If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.

For information about this process, see Add an S2-encrypted Z-Wave device.

As an S0 device:

If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.

1. Remove the battery tab from the sensor.
2. Place the Z-Wave controller into Add Mode. 
3. Press the button on the sensor. The network LED on the sensor will turn solid green, to indicate a successful enrollment.