Skip to main content
Knowledge Base

Which panels and devices are compatible with Z-Wave SmartStart?

  1. Last updated
  2. Save as PDF

To use Z-Wave SmartStart, both the Z-Wave controller (i.e., security panel, hub, module, etc.) and the Z-Wave device must be SmartStart-enabled.

For information about Z-Wave SmartStart and adding devices, see What is Z-Wave SmartStart? and Add or remove a Z-Wave SmartStart-enabled device.

Supported Z-Wave SmartStart controllers

Supported Z-Wave SmartStart thermostats

*Important: ADC-T2000 firmware versions 2.01+ are required for SmartStart compatibility.

Supported Z-Wave SmartStart locks

*Important: The BE468ZP and BE469ZP are only compatible with Qolsys, DSC, SEM-Honeywell/ADEMCO Vista, Interlogix, and 2GIG EDGE security panels, and the lock must be produced in December 2019 or later with Fw1 version 11.00+. The production date can be found on the bottom of the box's label in the MMDDYY(letter) format, and the Fw1 version can be found in the Z-Wave equipment list under Z-Wave Application Versions.

Supported Z-Wave SmartStart lighting & appliance control

Supported Z-Wave SmartStart garage devices

Supported Z-Wave SmartStart water management devices

*Important: The IQ Water Valve (QZ2160-840) is compatible with the following Alarm.com-supported security panels: Qolsys, DSC, SEM-Honeywell/ADEMCO Vista, Interlogix, and 2GIG GC2e, GC3e, and EDGE.

Supported Z-Wave SmartStart shades

Other supported Z-Wave SmartStart devices