Skip to main content
Knowledge Base

Emergency Call Button with Qolsys Transmitter

  1. Last updated
  2. Save as PDF

Emergency Call Buttons can be placed in fall risk areas such as stairs and bathtubs.

Specifications

SKU ADC-EPB-BC2.1-GE
Enclosure
  • 4.75 in. x 2.25 in. (Diameter x Depth)
  • Black, ABS plastic base with slip-resistant feet
  • 3 x AAA battery housing for optional audible message on button press
  • Red, ABS plastic, spring-loaded push button
Electronic Signaling

Battery-powered filter circuit with integrated 319.5 MHz (crystal-controlled) Qolsys-compatible transmitter with 64-minute supervisory interval
Sensing Interface Filtered, normally open (i.e. when not pressed), momentary contact switch
Battery Life 2+ years

Installation

  1. Place the sensor within 100 feet of the base station.
  2. The sensor can be mounted using the included mounting plate and mounting hardware, or simply place the sensor on a flat surface in a visible location.
  3. Verify that the On/Off switch on the base of the button is set to the On position.
     
    Caution: The device may signal a tamper if the emergency button is pressed within the first two seconds after the On/Off switch is set to the On position.

Use

Press and hold the emergency button for one second.