Enroll, delete, or reset a Zooz Titan Water Valve Actuator
The Zooz Titan Water Valve Actuator can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing a Zooz Titan Water Valve Actuator, see Zooz Titan Water Valve Actuator - Installation Guide.
To enroll a Zooz Titan Water Valve Actuator
As a SmartStart device:
It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).
For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.
As an S2 device:
If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.
For information about this process, see Add an S2-encrypted Z-Wave device.
As an S0 device:
If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.
- Place the Z-Wave controller into Add Mode.
- Quickly press the Z-Wave Button three times. The yellow LED will illuminate and the device will make a short beep sound.
- When successfully enrolled, the green LED will illuminate for 1 second with two short beep sounds.
To delete a Zooz Titan Water Valve Actuator
- Place the Z-Wave controller into Delete Mode.
- Quickly press the Z-Wave Button three times. The yellow LED will illuminate and the device will make a short beep sound.
- When successfully enrolled, the green LED will illuminate for 3 seconds with two short beep sounds.
To reset a Zooz Titan Water Valve Actuator
- Press and hold the Z-Wave button for 10 seconds.
- Release and then immediately quickly tap the Z-Wave Button five times.