Enroll, delete, or reset a Jasco Smart Flood/Freeze Sensor

As a SmartStart device:

It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).

For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.

As an S2 device:

If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.

For information about this process, see Add an S2-encrypted Z-Wave device.

As an S0 device:

If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.

1. Place the Z-Wave controller into Add Mode.
2. Remove the top cover of the sensor.
3. Verify the battery is installed with the correct polarity and the battery tab has been removed, or verify the micro USB is plugged into USB port.
4. Press and release the programming button. The red LED will flash quickly as it searches for a network.
5. After 25 seconds, the LED will stop flashing if the sensor is not added to the network. Press the programming button to manually start the add process.
   • If it times out, the LED will stop flashing. Press and release the programming button again.
6. The red LED will turn on for 3 seconds to confirm the sensor has been added in the network.