Enroll, delete, or reset an IQ Water Valve (QZ2160-840)
The IQ Water Valve (QZ2160-840) can be enrolled into or deleted from a Z-Wave network following the instructions below.
For more information about installing an IQ Water Valve (QZ2160-840), see IQ Water Valve (QZ2160-840) - Installation Guide.
To enroll an IQ Water Valve (QZ2160-840) into a Z-Wave network:
As a SmartStart device:
It is recommended to enroll this device as a SmartStart device to eliminate the need to put Z-Wave controllers into Add Mode or to trigger devices (as is the case when enrolling non-SmartStart S2 devices).
For information about SmartStart compatibility and the enrollment process, see Add or remove a Z-Wave SmartStart-enabled device.
As an S2 device:
If the Z-Wave controller is not SmartStart-compatible, it is recommended to enroll this device as an S2 device for enhanced security and encryption features.
For information about this process, see Add an S2-encrypted Z-Wave device.
As an S0 device:
If the Z-Wave controller is not SmartStart or S2-compatible, this device can be enrolled in the traditional way as an S0 device.
- Place the Z-Wave controller into Add Mode.
- Press the Touch Sense button three times. The device should beep with each press.
- The water valve is in inclusion mode when the LED is flashing yellow and the device is beeping.
- Successful pairing is indicated by the LED turning green for 1 second with two short beeps.
To delete an IQ Water Valve (QZ2160-840) from a Z-Wave network:
- Place the Z-Wave controller into Delete Mode.
- Press the Touch Sense button three times. The device should beep with each press.
- The water valve is in inclusion mode when the LED is flashing yellow and the device is beeping.
- Successful pairing is indicated by the LED turning green for 1 second with two short beeps.
To reset an IQ Water Valve (QZ2160-840):
Note: This should only be used in the event the Z-Wave network’s primary controller is missing or otherwise inoperable
- Press and hold the Touch Sense button until ten beeps are heard, then quickly press the Touch Sense button five more times.
- The LED will turn yellow for 1 second then green for 2 seconds with a long beep, indicating a successful reset.
Compatibility Alert
This device is compatible with the following Alarm.com-supported security panels: Qolsys, DSC, SEM-Honeywell/ADEMCO Vista, Interlogix, and 2GIG GC2e, GC3e, and EDGE.