Factory reset an ADC-V721W to its default settings

Last updated
Save as PDF

Resetting a device to its factory default settings removes all of its existing programming and memory. Most devices must be removed from the account and re-enrolled after a factory reset.

Important: Wait at least 2 minutes for the device to power on fully before performing the following procedure. The factory reset might fail if the device is still powering on.

Reset procedure	Reset button location	Reset button image
Hold the [WPS] button until the LED rapidly flashes red and green, which usually happens after 15 seconds. After it is reset, the ADC-V721W reverts to access point mode (blinking white).	The reset button is located in the same place as the [WPS] button, which is on the back of the camera.

Reset procedure

Reset button location

Reset button image

Hold the [WPS] button until the LED rapidly flashes red and green, which usually happens after 15 seconds.

After it is reset, the ADC-V721W reverts to access point mode (blinking white).

The reset button is located in the same place as the [WPS] button, which is on the back of the camera.

Important: Once a video device has been reset, it is normal for the LED to turn off momentarily. It is best to leave the video device plugged into power and undisturbed for 2 minutes after performing the factory reset.