Skip to main content
Knowledge Base

Fixed Lens (ADC-V510) - Installation Guide

  1. Last updated
  2. Save as PDF

Required items for installation: 

  • ADC-V510 camera and power adapter (included)
  • Broadband (Cable, DSL, or Fiber-optic) Internet connection with router
  • Windows or Mac computer
  • Login/password for the customer account
  • Ethernet cable for the camera
  • If the camera will be connected to a wireless network, you will need:
    • the case-sensitive SSID (wireless network name)
    • the network WEP or WPA key (if encryption is enabled at the router)

For a detailed list of this video device's features, see Fixed Lens (ADC-V510) - Data Sheet.

clipboard_e01179fa397f895bfc3cef022a3782b1e.png

Install the cameras:

Note: Complete these steps prior to mounting the camera in its final location.

  1. Connect the camera to the router via an Ethernet cable.
  2. Connect the camera to an AC power adapter and plug the adapter into a non-switched outlet.
  3. Wait two minutes for the camera to connect to the Internet.
  4. Add the device to the account by using the Alarm.com app Video Installation Wizard, or by using a web browser and entering the following web address: www.alarm.com/addcamera (you will need the customer’s user name and password if using the Alarm.com customer website).
    Important: The ADC-V510's Wi-Fi information must be configured while it is still connected with an Ethernet cable.
     
  5. Once the camera is enrolled and configured on the account, power down the camera and install it in its final location using the included hardware.

For information about how to reconnect a camera to a network, see Reconnect a camera to a Wi-Fi network if the router, network equipment, or wireless settings change.

clipboard_e4d71475450bac8be75bffe1193ef5a69.png

LED guide

LED pattern Status Description

Solid green

LED solid green.svg

 Connected to the internet

Local network and internet connection with Alarm.com IP. 

Note: This camera does not have a flashing green status. 

Solid blue

LED solid blue.svg

 Privacy mode

Privacy mode is active. This is illuminated on the P. To toggle privacy mode on/off, press and hold P.

Solid red

LED solid red.svg

 Power on, or no network connection

Power on, system booting up typically 60-90 seconds.

If solid red for longer than 60-90 seconds, then there is no local or Internet connection.

Blinking red

LED blinking red.svg

 Factory reset

The camera is restoring to factory default settings. 

Caution: If the camera is already installed, it may need to be removed from the Alarm.com account and re-added after a factory reset. 

To perform a factory reset, press and hold the reset button for about 60 seconds. The P LED also illuminates solid blue while holding the reset button.