Factory reset an ADC-V731B to its default settings

Last updated
Save as PDF

Resetting a video device to its factory defaults removes all programming and memory from the device.

Important: Wait at least two minutes for the video device to power on fully before performing the following procedure. The factory reset might fail if the device is still powering on.

Reset procedure	Reset button location	Reset button image
Press and hold the multi-purpose/reset button until the LED is flashing green and red (about 12 seconds), then release the button. The camera will reboot with factory default settings.	The multi-purpose/reset button is underneath the camera's housing, on the side of the battery pack cradle. Press the oval button located on the bottom of the device to release the housing. Remove the housing.

Reset procedure

Reset button location

Reset button image

Press and hold the multi-purpose/reset button until the LED is flashing green and red (about 12 seconds), then release the button.

The camera will reboot with factory default settings.

The multi-purpose/reset button is underneath the camera's housing, on the side of the battery pack cradle.

Press the oval button located on the bottom of the device to release the housing.
Remove the housing.

Important: Once a video device has been reset, it is normal for the LED to turn off momentarily. It is best to leave the video device plugged into power and undisturbed for two minutes after performing the factory reset.