Factory reset an ADC-VS1 to its default settings

Resetting a video device to its factory defaults removes all programming from the device. This is useful for troubleshooting and reusing equipment. 

Important: Wait at least 2 minutes for the video device to power on fully before performing the following procedure. The factory reset might fail if the device is still powering on.

Reset procedure	Reset button location	Reset button image
Press and hold the Reset button until the LED flashes red and green rapidly. This usually happens after 15 seconds.	The Reset button is inside the pinhole labeled Reset.

Once a video device is reset, it is normal for the LED to turn off momentarily. Wait for 2 minutes after performing a factory reset before attempting to use the device again.