Are Remote Temperature Sensors included in Network Rediscoveries?
No. Alarm.com Remote Temperature Sensors do not respond to a Network Rediscovery. Therefore, it is important to set up the rest of the Z-Wave network and run a Network Rediscovery before learning in Temperature Sensors.
To correctly install an Alarm.com Remote Temperature Sensor:
- Install all other Z-Wave devices and run a Network Rediscovery by following the instructions in this manual. If the panel supports Link Quality Indicators, verify all devices show a Good rating on the Z-Wave Equipment list.
- Place the Temperature Sensors in their final locations.
- Put the panel into Add Mode.
- Add the sensors by pressing the buttons on the sides of the devices.
- Verify that the sensors show up on Alarm.com and report changes in temperature appropriately. No additional Network Rediscovery is necessary.