Run Scenes from the Qolsys IQ Panel 2
The Qolsys IQ Panel 2 has the ability to run Alarm.com Scenes locally at the panel. For more information about configuring Scenes, see Create/edit a Scene.
Compatibility
To following are required to locally run Scenes.
- The Qolsys IQ Panel 2 must be on software version 2.4.0+
- Local Scenes support must be enabled in panel programming
- The panel must have only one partition
- Local Scenes support is not compatible with multiple partitions. If multiple partitions are enabled on the panel, local Scenes support is automatically disabled.
- Local Scenes support is not compatible with multiple partitions. If multiple partitions are enabled on the panel, local Scenes support is automatically disabled.
Note: Remote Scenes can still be performed even if local Scenes are disabled.
To configure which Scenes appear on the panel:
This option is only available to update using the Alarm.com customer website.
- Log in to the Alarm.com customer website.
- In the Welcome card, click Scenes.
- Click
on the scene to configure. - Click to select Show on Panel for the scene to display on the panel, or deselect Show on Panel for the scene to not display on the panel.
- Click Save. Allow a few minutes for the changes to apply at the panel.
To locally run Scenes using the Qolsys IQ Panel 2:
- From the home screen, tap
.
- If this option does not appear on the panel's screen, verify the compatibility requirements. For more information, see Compatibility.
- Tap to select the Scene to run.
Note: Scenes that include a disarm command require a valid user code to be entered at the panel when the scene is performed. If the duress code is used, a duress alarm will be triggered, as it would during a normal disarm.
