Interlogix NX - Z-Wave LED Statuses
The following tables outline the Z-Wave LEDs for Interlogix NX modules by module versions.
Dual-Path LTE module Z-Wave LEDs
On Dual-Path modules, the Z-Wave LED is only LED 5.
|
LED 5 flashes |
Device status or error |
Description |
|---|---|---|
|
1 |
Successful add node/remove node/replication (lasts 60 seconds) | After receiving this signal leave all devices by the LTE module for 1 minute. Locks must be left next to the module for 4 minutes. |
|
2 |
Delete Mode (lasts 120 seconds or until a device is deleted) | This mode can delete a Z-Wave device from a Z-Wave network. A device can only be in one network at a time and must receive a delete command before it can be learned into a new network. |
|
3 |
Add node attempt failed because node already in the network (lasts 60 seconds) | The device that was attempted to be added to a network is already in a network and must be deleted before it can join a new network. |
|
4 |
Add Mode (lasts 120 seconds or until a device is added) |
This mode can add a device to the local Z-Wave network. Devices cannot be added to a network if they are already a part of a network. |
| 5 | Replicate Mode | - |
|
6 |
Learn mode error (lasts 60 seconds) |
The device was not successfully added to the Z-Wave network. |
| 7 | No node info | - |
| 8 | No other nodes are in the network (lasts until a device is added to the network) | No devices have been added that can be controlled by the module yet. See above for instructions on how to add devices. |
CDMA/HSPA/LTE module Z-Wave LEDs
On CDMA/HSPA/LTE modules, the Z-Wave LEDs are LED 2 and LED 5.
| LED 2 | LED 5 | Device Status or Error | Description |
|---|---|---|---|
| 4-blink | Add mode (lasts 120 seconds or until a device is added) | In this mode, add a device to the local Z-Wave network. Devices cannot be added to a network if they are already a part of a network. | |
| 2-blink | Delete mode (lasts 120 seconds or until a device is added) | In this mode, delete a device from a Z-Wave network. A device can only be in one network at a time and must receive a delete command before it can be learned into a new network. | |
| Solid | Successful add node/remove node/replication (lasts 60 seconds) | After receiving this signal leave all devices by the GSM Module for 1 minute. Locks must be left next to the Module for 4 minutes. | |
| Solid with one blink | Add node attempt failed because node already in the network (lasts 60 seconds) | The device you attempted to add to a network is already in a network and must be deleted before it can join a new network. | |
| 2-blink | No other nodes are in the network (lasts until a device is added to the network) | No devices have been added that can be controlled by the cellular module yet. See above for instructions on how to add devices. | |
| 5- blink | Learn mode error (lasts 60 seconds) | The device you attempted to add into a Z-Wave network was not successfully added. | |
| 6-blink | No Home ID present (lasts until the module connects to Alarm.com and is configured) | When the cellular module first connects to Alarm.com it is configured with a necessary unique network ID. |