Skip to main content
Knowledge Base

Enroll or delete a Yale Real Living T1L Touchscreen Deadbolt (YRD120)

  1. Last updated
  2. Save as PDF

Z-Wave locks use encrypted communication over Z-Wave, meaning their communication is completely secure. With this added security, the lock and the controller must use additional Z-Wave commands to enroll and communicate. With each additional command sent, the probability of a communication breakdown increases.

For information about hardware installation, see Yale Real Living T1L Touchscreen Deadbolt (YRD120) - Installation guide.

Important: Do not add or delete user codes locally to or from the lock. Only use the Alarm.com customer website for user code management. 

To mitigate the chances of an enrollment failure for locks, complete the following during installation. 

To enroll a Yale Real Living T1L Touchscreen Deadbolt (YRD120) into a Z-Wave network:

  1. Begin with the lock within 6 feet of the Z-Wave controller.
  2. Place the Z-Wave controller into Add Mode.
  3. Remove the battery cover.
  4. Press the Yale Z-Wave icon.png button and hold until the unit beeps two times.
  5. Release the button and network joining automatically begins.
  6. Replace the battery cover.
  7. Wait 2 minutes before locally operating the device.
  8. Verify that the lock shows up on the Alarm.com customer website and responds to lock/unlock commands.

To delete a Yale Real Living T1L Touchscreen Deadbolt (YRD120) from a Z-Wave network:

  1. Remove the battery cover from the lock.
  2. Place the panel into Delete Mode.
  3. Press and hold the YRD156 enroll icon.png button on the lock until it beeps five times.
  4. Replace the battery cover.