Skip to main content
Knowledge Base

Enroll or delete a Yale Real Living Push Button Lever (YRL210/YRT210)

Z-Wave locks use encrypted communication over Z-Wave, meaning their communication is completely secure. With this added security, the lock and the controller must use additional Z-Wave commands to enroll and communicate. With each additional command sent, the probability of a communication breakdown increases.

For information about hardware installation, see Yale Real Living Push Button Lever (YRL210/YRT210) - Installation guide.

Important: Do not add or delete user codes locally to or from the lock. Use only the Alarm.com customer website for user code management. 

To mitigate the chances of a enroll failure for locks, complete the following during installation. 

To enroll a Yale Real Living Push Button Deadbolt (YRD210 into a Z-Wave network:

  1. Begin with the lock within 6 feet of the panel or module.
  2. Place the panel into Add Mode.
  3. Enter the master code, followed by [#].
  4. Press [7], followed by [#].
  5. Press [1], followed by [#].
  6. Wait 2 minutes before locally operating the device.
  7. Verify that the lock appears on the Alarm.com customer website and responds to lock/unlock commands.

To delete a Yale Real Living Push Button Deadbolt (YRD210) from a Z-Wave network:

  1. Place the panel into Delete Mode.
  2. Enter the master code, followed by [#].
  3. Press [7], followed by [#].
  4. Press [3], followed by [#].