Skip to main content
Knowledge Base

Enroll or delete a Yale Real Living Push Button Deadbolt (YRD210)

  1. Last updated
  2. Save as PDF

Z-Wave locks use encrypted communication over Z-Wave, meaning their communication is completely secure. With this added security, the lock and the controller must use additional Z-Wave commands to enroll and communicate. With each additional command sent, the probability of a communication breakdown increases.

For information about hardware installation, see Yale Real Living Push Button Deadbolt (YRD210) - Installation guide.

Important: Do not add or delete user codes locally to or from the lock. Use only the Alarm.com customer website for user code management. 

To mitigate the chances of an enrollment failure for locks, complete the following during installation. 

To enroll a Yale Real Living Push Button Deadbolt (YRD210) into a Z-Wave network:

  1. Begin with the lock within 6 feet of the panel or module.
  2. Place the panel into Add Mode.
  3. Enter the master code, followed by [#].
  4. Press , followed by [#].
  5. Press , followed by [#].
  6. Wait 2 minutes before locally operating the device.
  7. Verify that the lock appears on the Alarm.com customer website and responds to lock/unlock commands.

To delete a Yale Real Living Push Button Deadbolt (YRD210) from a Z-Wave network:

  1. Place the panel into Delete Mode.
  2. Enter the master code, followed by [#].
  3. Press , followed by [#].
  4. Press , followed by [#].