Enroll or delete a Yale Real Living B1L Push Button Deadbolt (YRD110)
Z-Wave locks use encrypted communication over Z-Wave, meaning their communication is completely secure. With this added security, the lock and the controller must use additional Z-Wave commands to enroll and communicate. With each additional command sent, the probability of a communication breakdown increases.
For information about hardware installation, see Yale Real Living B1L Push Button Deadbolt (YRD110) - Installation guide.
Important: Do not add or delete user codes locally to or from the lock. Only use the Alarm.com Alarm.com customer website and Alarm.com app for user code management.
To mitigate the chances of an enrollment failure for locks, complete the following during installation.
To enroll a Yale Real Living B1L Push Button Deadbolt (YRD110) into a Z-Wave network:
- Begin with the lock within 6 feet of the Z-Wave controller.
- Place the Z-Wave controller into Add Mode.
- Remove the battery cover.
- Press the
button and hold until unit beeps two (2) times. - Release the button and network joining automatically begins.
- Replace the battery cover.
- Wait two minutes before locally operating the device.
- Verify that the lock shows up on the Alarm.com customer website and Alarm.com app and responds to lock/unlock commands.
To delete a Yale Real Living B1L Push Button Deadbolt (YRD110) from a Z-Wave network:
- Place the Z-Wave controller into Delete Mode.
- Remove the battery cover.
- Press the button and hold until unit beeps five (5) times.
- Release the button and network removal automatically begins.
- Replace the battery cover.