Skip to main content
Knowledge Base

Enroll or delete a Yale Assure Push Button Lever Lock (YRL216)

  1. Last updated
  2. Save as PDF

Z-Wave locks use encrypted communication over Z-Wave, meaning their communication is completely secure. With this added security, the lock and the controller must use additional Z-Wave commands to learn-in and communicate. With each additional command sent, the probability of a communication breakdown increases.

For information about hardware installation, see Yale Assure Push Button Lever Lock (YRL216) - Installation Guide.

Important: Do not add or delete user codes locally to or from the lock. Only use the Alarm.com web interface for user code management. 

To mitigate the chances of a learn-in failure for locks, complete the following during installation. 

To enroll a Yale Assure Push Button Lever Lock (YRL216) into a Z-Wave network:

  1. Begin with the lock within 6 feet of the panel or module. 
  2. Place the panel into Add Mode.
  3. Enter the master code, followed by a press of the [⚙ Gear Button].
  4. Press [7], followed by the [⚙ Gear Button].
  5. Press [1], followed by the [⚙ Gear Button].
  6. Wait 2 minutes before locally operating the device.
  7. Verify that the lock appears on Alarm.com customer website and responds to lock/unlock commands.

To delete a Yale Assure Push Button Lever Lock (YRL216) from a Z-Wave network:

  1. Place the panel into Delete Mode.
  2. Enter the master code, followed by a press of the [⚙ Gear Button].
  3. Press [7], followed by the [⚙ Gear Button].
  4. Press [3], followed by the [⚙ Gear Button].